1st gen Toyota Sequoia 2001–2007

This page is a draft. It has not been approved yet, so read it with care.

Watch out for

Reputation: what owners and the press report. Tap one to see what to check.

Rusted frame All years Walk away if found

What to check: Get the truck on a lift and look along the whole frame, the rear crossmember and the mounts near the rear axle for scale, flaking and holes.

Autotrader calls frame rust the 1st gen's main concern. Nineteen owners of 2001s on one CarComplaints.com page report frame or underbody rust, several with frames judged unsafe and Toyota offering no help. Wikipedia says the Sequoia shared a frame rust recall with the Tacoma and Tundra, without naming its years.

Sources ^1,2,3
Stability control engaging for no reason 2001–2003

What to check: Watch for the VSC and TRAC lights, and feel for the brakes biting as you pull away from a stop.

The most reported 2001 problem on CarComplaints.com, and the worst 2003 problem there is the VSC and TRAC lights staying on. Some 2003s were recalled to reprogram the stability control unit.

Sources ^4,5,6,7
Power rear window stops working All years

What to check: Run the tailgate window down and up from the key and the dash switch.

The second-worst 2003 problem on CarComplaints.com, and Edmunds' 2005 page lists rear window failures among owners' reports.

Sources ^6,8
Timing belt with no proof it was changed All years One source so far

What to check: Ask for the receipt for the last timing belt change, and whether the water pump was done with it.

Two members of one IH8MUD thread on buying a 1st gen raise the 4.7L's timing belt. One says to check the belt service, with the water pump, PCV valve and spark plugs done at the same time.

Sources ⁹

Watch out for

Sources